top of page

General Sticker and Decal Installation Tips


Thank you very much for your business. Here are a few instructions for you to have a successful decal install. Installing decals is challenging so please take your time and let us know if you need help BEFORE install if you are unsure.


For decals, please be sure surface is 100% clean and non-porous. Peel transfer tape very slowly.

Please prepare your decal for install after shipping. During shipping your decal may be subjected to severe heat or cold and rough handling. The longer the distance, the greater the chance for issues. For large decals it can be very difficult to install them correctly. There may be some wrinkles in the TRANSFER TAPE, but don’t worry the decal is still good. This is very common from being rolled up and shipped. Just follow the directions below to get rid of as many bubbles as possible. We always recommend using a professional decal installer if you are not skilled in the art of decal installation.

Pre install tip: Lay your decal on a flat surface in a warm environment. Gently lift the transfer tape and with a squeegee or credit card gently press out the wrinkles from shipping. There may some wrinkles in the transfer tape due to shipping but press them out gently the best you can and it will not affect the install. Just be sure decal in laying flat on backing.



**VERY IMPORTANT** INSTALL IN SHADE, IN TEMPERATURE AS CLOSE TO 70 DEGREES AS POSSIBLE. DECALL WILL NOT STICK TO THE SURFACE IN HOT SUN


Step 1 – Clean the install area thoroughly with rubbing alcohol or soap and water.

Step 2 – Prepare the sticker for application by firmly/carefully rubbing a squeegee or credit card across the clear transfer tape. Slowly lift the transfer tape to ensure the decal is attached. If the decal is not attached, use a razor to gently lift the decal up along with the transfer tape. Do this for all parts of the decal not attached to the transfer tape.

Step 3 – Carefully peel paper backing off the sticker. If any part of the decal is not attached to the transfer tape, use a razor to help lift the decal onto the transfer tape.

Step 4 – Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. USE water/soap mist to assist in install. *For larger decals please refer to attached

Step 5 – Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.


FOR CARBON FIBER

Please take extra care as carbon fiber does not stick well to the transfer tape. Go slow and take your time to avoid mistakes with installation. Use heat and press firmly on WELL CLEANED surface after install.


GLOW IN THE DARK

Please make sure to follow the steps above as well as using heat after install to secure it to the surface.

ALSO: Glow in the dark requires light source to glow. Shine light on it, then it will glow for a short time. It will not glow without light stimulation.

6 views0 comments

Recent Posts

See All

Comments


bottom of page